What do I need to prepare for investing in asbestos board equipment?

Asbestos board equipment

 

       Asbestos board equipment is a new type of tracked equipment specializing in the production of thermal insulation and rain-proof cement large tiles. It is characterized by low price, high degree of automation, and random cutting. It is equipped with cement tile forming trowel and wet cutter. , Cement trowel, can continuously produce 26 layers, and can produce color tiles, with low cost, large profit, and large production volume. It is an ideal equipment for getting rich in rural areas.

 

　　 1. Choose a venue: Asbestos board equipment does not choose a venue, and does not need to harden the ground, (woods and open areas are acceptable)

 

        2. Pre-embedded outer tube: set the outer tube to 1300-1500mm and the inner cavity of the outer tube 790mm. Straighten the two outer tubes with a horizontal ruler (level both ends), then pull the wire to embed the outer tube in turn, and then embed A 150*&150 pit is dug around the upper end of the pipe and poured with concrete to prevent the outer pipe from sinking in the rainy season.

 

        3. Pave the upper end of the lifting rod with 40*40 angle steel (track), put the asbestos tile machine on the track, adjust the guide wheels on both sides of the machine, the distance between the guide wheel and the track is 5-8mm, and put the steel wire rope on the drum Pull to the other end of the track and fix it with a ground cone.

 

　　 4. Stir the bottom mold material in advance and add it to the hopper, (the bottom mold material is mixed with sand to form a thin mud), start the motor switch, and pull out the bottom mold.

 

　　 5. Ascend the lifting pipe one hole distance (insert a nail in the hole to prevent it from falling), place the machine on the track, add the mixed cement grout, start the motor and the vibration switch to start the production of cement asbestos board equipment.

 

　　 6. ​​Check and clean the machine after the shift, do not let water invade the motor, fill the chain with oil, adjust the m6 bolts at both ends of the mixing shaft at intervals to make the sealing ring work.

 

　　 7. Host motor 1.5kw vibrator 0.22w. Use lighting electricity.