How to extend the service life of the scraper of the calcium_Gongyi Fangrui Zhenghe Machinery Factory

your location： Gongyi Fangrui Zhenghe Machinery Factory > news >

How to extend the service life of the scraper of the calcium

Author：admin source：未知 Release date：2026-02-26 10:40

Information summary：

To extend the service life of the silicon dioxide calcium board equipment scraper,the key lies in accurate installation,strict pressure control,reduction of abrasive particles,and standardized maintenance,which can significantly reduce wear...

　　To extend the service life of the silicon dioxide calcium board equipment scraper,the key lies in accurate installation,strict pressure control,reduction of abrasive particles,and standardized maintenance,which can significantly reduce wear and prevent blade chipping.

　　1.Accurate Installation and Parameter Control

　　①Select anti-wear alloy and hard alloy scrapers,match the flatness of the backing knife,and install them by tightening evenly from the middle to both sides to ensure the blade body is straight and parallel to the board surface.

　　②Adjust the angle properly,adjust the pressure to just scrape off the slurry without excessive pressure that accelerates the wear of the blade edge.

　　③Add axial micro-swing to allow the blade edge to be evenly stressed,reducing local uneven wear.

Calcium silicate board equipment 　

　2.Reducing Abrasive Particles and Slurry Control

　　①Multi-stage filtration of the slurry to remove quartz sand,fiber hard lumps,etc.,reducing the wear of the scraper.

　　②Control the viscosity and solid content of the slurry to avoid dryness,agglomeration,and accumulation,reducing adhesion and impact on the blade surface.

　　③Add iron and impurity removal devices at the feed inlet to prevent metal particles from scratching the blade edge.

　　3.Daily Maintenance and Timely Repair

　　①Clean the blade surface and blade seat after each shift,remove residual slurry to prevent dryness and scraping.

　　②Regularly inspect the blade edge,promptly repair minor chipping or dulling to prevent small defects from expanding;replace immediately if the wear exceeds 1/3.

　　③Lubricate the guide rails of the knife holder and the cylinder to ensure smooth operation,reducing vibration and uneven wear.

　　4.Operating Specifications

　　①Avoid empty-load scraping,sudden start and stop,to prevent impact and blade chipping;raise the blade before stopping the conveyor.

　　②Never strike the scraper with hard objects.Handle installation and disassembly gently to protect the integrity of the blade edge.

【related suggestion】

Previous：A simple way to extend the service life of asbestos shingle
: next：What are the daily cleaning methods for formed nets and felt

Back to list

Product Center

Asbestos pipe equipment

Calcium silicate board equipmen

Asbestos tile equipment

Cement fiber board equipment

Calcium silicate board producti