How to solve the problem of deviation in the silicon calcium_Gongyi Fangrui Zhenghe Machinery Factory

your location： Gongyi Fangrui Zhenghe Machinery Factory > news >

How to solve the problem of deviation in the silicon calcium

Author：admin source：未知 Release date：2026-04-09 09:24

Information summary：

Deviation of the silicon calcium plate forming equipment will directly lead to uneven thickness of the plates,uneven edges,and increased equipment wear.It needs to be comprehensively investigated and handled from the aspects of machinery,ten...

Calcium silicate board equipment

　　First,check whether the forming mesh belt or idler rollers are level.If the frame is deformed or the anchor bolts are loose,it will cause a height difference on both sides of the mesh belt,resulting in deviation.It is necessary to correct the level of the frame and tighten the bolts in time.Secondly,check the operation of the idler rollers.If the idler rollers do not rotate flexibly,are clogged with slurry,or have damaged bearings,it will cause inconsistent resistance on both sides and require cleaning the accumulated slurry,replacing the bearings,and ensuring that all idler rollers are parallel and running synchronously.

　　Adjust the tensioning device.Loosely tensioned mesh belt or uneven tension on both sides are common causes.It should be moderately tightened and the tension of both sides of the mesh belt should be made consistent by adjusting the tensioning screw to avoid being overly tight on one side.At the same time,check the feeding system.If the slurry distribution is uneven or there is excessive accumulation on one side,it will cause the mesh belt to be overloaded and require adjusting the height and opening of the feeding scraper to ensure uniform layer thickness.

　　In addition,adjust the position of the guide rollers.When there is deviation,the angle of the guide rollers can be slightly adjusted to make the mesh belt automatically return to the correct position.During long-term operation,good cleaning and maintenance should be done to prevent the slurry from adhering to the roller surface or the edge of the mesh belt,causing the equipment to deviate.Through the above systematic adjustments,the deviation of the forming equipment can be well solved,ensuring stable plate formation and improving the product qualification rate.

【related suggestion】

Previous：When cleaning the dust in the dust removal system of the cal
: next：没有了

Back to list

Product Center

Asbestos pipe equipment

Calcium silicate board equipmen

Asbestos tile equipment

Cement fiber board equipment

Calcium silicate board producti