How much is the 　　 Fiberboard production line? It ranges from 80,000 to 800,000, and must be purchased from a regular manufacturer. Cement fiberboard equipment has high automation, low labor intensity, assembly line operation, no noise and no three wastes in the production process. Fiberboard equipment has low energy consumption, does not require high temperature and high pressure, and uses a chemical reaction to release heat by itself. A cement fiberboard production line that is worth buying can meet the production process requirements.

 

　　Using method: inspection preparation before operation, site cleaning and application of release agent. The release agent is purchased by the user. It should be a non-toxic, odorless, non-irritating, good isolation effect, non-corrosive to the countertop and products, and low-cost release agent to prevent the product from sticking to the surface of the venue and difficult to lift the board. Check and adjust the size of the molding cavity. The vibrating plate should be in a free state, and there should be 1.5~2.5mm gaps between the four sides and the surrounding parts, and the height position should be 1.5~2mm higher than the bottom of the front end of the forming scraper; the height of the forming scraper to the bottom surface of the wall; the front end (connecting with the vibrating plate) ) 59mm cement fiberboard production line manufacturer, the rear end is 58mm; the wallboard machine is pulled into the station, the inside of the two front wheels are stuck on the outside of the two strips, and the rear ends of the left and right wallboards are also stuck on the outside of the two strips. , Adjust the extruder to working condition. [2] Check whether the fastening parts are loose (especially the front and rear support plate bolts and the bolts of the electrical system should be **checked), check the oil level of the reduction box and make it meet the requirements; The grease nipple on the rod presses the grease; turn on the main power switch to start the rotation of the main motor stirring knife. Start the main motor of the wall panel machine and drive the stirring knife to run dry. If there is any abnormality, it should be shut down immediately for inspection. Be careful not to start the cement fiberboard production line with the vibrator in the no-load state, so as to avoid damage to the parts.

 

       How much is the Fiberboard production line

 

       When buying, in addition to paying attention to the performance and quality of the equipment itself, the price is undoubtedly the customer's more attention, especially for equipment with more manufacturers in the market, you must be more cautious in buying, after all, the price of fiberboard production line does not count. Cheap.

 

       Generally, the price of fiberboard production line ranges from 80,000 to 800,000, which is affected by many factors, such as equipment manufacturers, specifications, quality, regions, market demand, etc. Different manufacturers have different product performance and quality, and the price is also different. There are differences, so when customers buy equipment, they must buy from a regular manufacturer.