How to prevent the residue of slurry in calcium silicate boa_Gongyi Fangrui Zhenghe Machinery Factory

your location： Gongyi Fangrui Zhenghe Machinery Factory > news >

How to prevent the residue of slurry in calcium silicate boa

Author：admin source：未知 Release date：2025-11-13 09:07

Information summary：

　　The core approach is to reduce slurry residue from the source and prevent corrosion and blockage through"post-production cleaning+downtime protection+regular maintenance".The specific measures are as follows:

　　1.Clean the calcium silicate board equipment immediately after production:avoid residue accumulation

　　Pulping system:After each production is completed,immediately rinse the stirring tank,slurry pump and slurry flow box with clean water,repeating this process 3 to 4 times.Then,dry the inner walls of the pipes with compressed air to ensure no slurry adheres.

Calcium silicate board equipment

　　Forming and conveying system:Use a scraper to clean the surface of the forming pressure roller and the conveying mesh belt,and then rinse with high-pressure water to prevent the slurry from drying and caking.Debris around the cutting table should be cleared in time to prevent it from falling into the gaps of the equipment.

　　Key pipelines:Regularly disassemble the slurry filter and valves,and manually clean the internal residues to prevent fine particles from blocking the channels.

　　2.Special protection during downtime:Blocking corrosive conditions

　　Short-term shutdown(within one week):Inject clean water or anti-rust liquid into the pulping system and pipelines to keep them moist and prevent the residual slurry from drying out.Run the machine without load for 5 minutes every day to allow the liquid to circulate.

　　Long-term shutdown(more than one week):Empty all slurry channels,blow off residual moisture with high-pressure air,apply anti-rust oil to metal parts(such as the inner walls of pipes and valves),and close the sealing covers.

　　3.Regular maintenance:Identify potential hazards in advance

　　Weekly inspection:Check if there is any slight blockage in the slurry pump and valves.Use thin iron wire to clear the small blockage points to prevent the problem from worsening.

　　Monthly maintenance:Disassemble components prone to material accumulation(such as the nozzle of the slurry box and the stirring blades),clean stubborn residues,check the corrosion of components,and replace aged seals in a timely manner.

【related suggestion】

Previous：How long is the overall cycle for a asbestos tile production
: next：When producing cement fiberboards of different densities,can

Back to list

Product Center

Asbestos pipe equipment

Calcium silicate board equipmen

Asbestos tile equipment

Cement fiber board equipment

Calcium silicate board producti