Fiber cement board production line
 

     The fiberboard production line is cured by variable frequency steam pressure. It has the advantages of light weight, high strength, multiple environmental protection, thermal insulation, sound insulation, breathing and humidity control, fire prevention, rapid construction, and reduced wall costs. At the same time, the inner layer is equipped with a reasonable layout of heat-insulating and sound-absorbing inorganic foamed profiles or other heat-preserving materials, with a high degree of production automation and a wide variety of specifications. Then the main reasons for the popularity of fiberboard production lines are as follows:

 

　　 1. The fiberboard production line complies with the policy and follows the trend of development. The new wall material should be developed from small pieces to large pieces, wet work to dry work, manual bricklaying, and column assembly or installation.

 

　 　2. Meeting the functional requirements of buildings: Nowadays, lightweight partition wall equipment needs to develop new multifunctional composite wall materials with high strength, light weight, energy saving, soil saving, waste utilization, and environmental protection. Nowadays, the development of walls is from clay to non-clay, from solid to hollow, from small to large, from heavy to light, and from high energy consumption to low energy consumption.

 

        3. Convenient construction. Because the lightweight partition wall equipment is a board type and has a scientific installation method, there is no need for reinforcement during construction, no construction columns, no door and window lintels, no door and window frames to install concrete bricks, which solves the problem of bricks. The cumbersome process in construction saves costs. It can be nailed and chiseled, and it is convenient for water, wire and pipe pre-buried, door and window installation and node treatment during construction.

 

　 　4. Wide range of raw materials: This lightweight partition board uses industrial residues fly ash, slag and eps foam particles as the main raw materials, which is waste utilization and reduces pollution.

 

        5. The Fiber cement board production line does not need to paint the lightweight partition wall board. Because of its high accuracy, it does not need to use a large amount of cement mortar to paint, so it can achieve saving effects in raw materials, labor costs and construction time, and it is convenient for scientific production technology to make products It has high accuracy, accurate stitching, and easy to process. It can be cut, sawed, and chipped. Change the difficult situation of brick wall burying in the past.